Victron SmartSolar MPPT 100/50
A 50A controller for larger 12V or 24V arrays. Match it using the panel array's cold voltage and short-circuit current, not watts alone.
View on AmazonThe useful bits in one place, grouped by what they actually do. No live prices here: Amazon prices and availability change too often to pretend otherwise.
Link disclosure: some links are Amazon affiliate links; others go directly to the supplier. Prices and availability can change.
Panels and chargers have to suit the whole system. Check battery voltage, panel cold Voc, input current and cable sizing before ordering.
A 50A controller for larger 12V or 24V arrays. Match it using the panel array's cold voltage and short-circuit current, not watts alone.
View on Amazon
A compact 20A controller for smaller arrays. The linked model supports 12V, 24V and 48V battery systems; use the correct published PV limit for your battery voltage.
View on Amazon
Two rigid panels giving 240W of rated panel power. Read the label on each panel before deciding whether to wire the pair in series or parallel.
View on Amazon
A 12V-to-12V DC/DC charger for controlled leisure-battery charging from the vehicle. Cable and fuse both sides for the designed current and cable run.
View on Amazon
A high-capacity 12.8V LiFePO₄ battery for larger off-grid systems. The linked product lists 8,038Wh energy, a 250A maximum continuous discharge and M8 terminals; check the current specification sheet before designing the installation.
View at Fogstar
The 425W LONGi panel used on Becky. Use the model datasheet to check dimensions, Voc, Isc and connector details before mounting or matching an MPPT.
View datasheetThese are the tanks, pump, sensor and fittings used for Becky's water system. Check tank dimensions, pump pressure and pipe size against the layout before ordering.
A Wydale plastics tank for fresh water, with a 5-inch non-vented screw cap and 3/4-inch outlet. Bobil lists dimensions of 600 × 310 × 500mm.
View at Bobil Vans
The compact tank from the Becky build. Bobil’s current standalone product page is no longer live, so this links to the supplier’s current tank catalogue instead.
View water tanks at Bobil Vans
A simple float sensor that fits through a 20mm hole and can drive an LED or buzzer when the waste tank reaches the sensor level.
View at Bobil Vans
A 12V 33-Series diaphragm pump with inlet filter and barbed fittings. Bobil lists 20 or 30PSI versions and roughly 7.5L/min open flow.
View at Bobil Vans
The push-fit pipe and fittings used on Becky. Bobil’s complete kit includes 12mm pipe, inserts, male and female adaptors, tees, Ys and stop valves.
View at Bobil Vans
Bobil’s plumbing kit includes an accumulator to smooth flow, reduce pump cycling and absorb expansion in the cold-water line. The supplier page is the verified reference for the kit component.
View plumbing kit at Bobil VansProtection devices and cables are selected for a particular circuit. The fuse protects the cable, so size the cable first and never uprate a fuse to cure nuisance blowing.
A weatherproof breaker enclosure for DC circuits. Confirm the required DC voltage, current, interrupt rating and any polarity requirement before relying on it for protection.
View on Amazon
A manual master switch for disconnecting the leisure electrical system. It is an isolator, not a fuse, and its continuous rating must exceed the expected load.
View on Amazon
Gives each 12V load its own labelled fuse and positive feed. Every branch still needs cable sized for the load, run length and fuse fitted to that circuit.
View on Amazon
Red-and-black thin-wall cable for low-current 12V or 24V branches. Do not select it from the advertised 14A figure alone: load, route, length and voltage drop all matter.
View on Amazon
For suitable battery, charger or inverter runs. Use correctly crimped lugs and calculate the required size from continuous current, length, temperature and voltage drop. Check the selected colour and length before ordering.
View on Amazon
A covered high-current busbar for joining and distributing positive or negative feeds. Check stud size, cable lugs and mounting clearance before fitting.
View at SplitCharge
A bolt-down Mega fuse holder for the main battery and inverter feeds. SplitCharge lists it up to 500A, for cables up to 70mm², with M8 studs.
View at SplitCharge
Fine-stranded copper cable for high-current battery and inverter links. SplitCharge lists this size at 345A, with red or black insulation and cut-length options.
View at SplitCharge
The Pi computer used as the basis for the van monitoring and display idea. Choose the 4GB variant, then add the correct 5V supply, storage and enclosure for the installation.
View at The Pi Hut
A 1024 × 600 capacitive display with HDMI and USB connections, compatible with the Raspberry Pi 5. It is suitable for a dashboard or local system display.
View at The Pi HutThe small fittings matter: keep solar entry points sealed, protect cables from sharp edges and treat mains AC as a separate system from the van's 12V DC wiring.
This is a mains AC socket — not a 24V accessory. A van mains installation needs the correct cable, earthing arrangement and RCD/MCB protection, installed and tested competently.
View on Amazon
Panel-mount USB charging outlets for the 12V system. Put each feed on a suitable fused branch and allow for the small standby draw when the sockets remain energised.
View on Amazon
A two-cable roof entry housing for the positive and negative solar leads. Bond it to a properly prepared surface and use glands matched to the cable diameter.
View on AmazonThese are installation products, not just accessories. Follow the heater and adhesive manufacturers' instructions, particularly around combustion, surface preparation and cure time.
An all-in-one diesel air-heater kit. Combustion intake and exhaust must remain outside the living space; route the hot exhaust safely and fit a working carbon-monoxide alarm.
View on Amazon
A high-strength assembly adhesive commonly used on caravans and motorhomes. Surface preparation, bead depth, working time and full cure are part of the job — follow Sika's current datasheet.
View on AmazonUse the calculators and guides to establish the electrical requirements first, then confirm the exact Amazon listing still matches them. Sellers can change descriptions, options and bundled parts without changing a short link.
Open the calculators